|
6th Corrigenda for IPCC 2006 Guidelines
- Volume 4-1, page 7.5, change “(e.g., Boreal Env. Res. 11, 2006)” to “(e.g.
see papers in Boreal Env. Res 11, 2006)”
- Volume 4-1, page 7.14, change “Cleary, 2005” to “Cleary et al., 2005”.
- Volume 4-1, page 7.23, change heading “SECTION 7.2: PEATLANDS MANAGED OR BEING
CONVERTED FOR PEAT EXTRACTION” to “SECTION 7.1: INTRODUCTION &
SECTION 7.2: PEATLANDS MANAGED OR BEING CONVERTED FOR PEAT EXTRACTION”.
- Volume 4-2, Page 11.15, Equation 11.7A should be (according to the text) equivalent to Equation 11.6. Thus the correct Equation 11.7A should be:
Equation 11.7A (REVISED)
Alternative approach to estimate FCR (using Table 11.2)

- In Volume 4-2, Page 11.17, Table 11.2, in the first term on the right hand side,
“Crop (T)” should be replaced with “(Crop (T) /1000)”. The correct equation on
the top of Table 11.2 should be: AGDM(T) (Mg/ha) = (Crop (T) /1000) *
slope(T) + intercept(T)
- In Volume 4-2, Chapter 11, Page 11.19, Paragraph 11.2.2, footnote “20”
should be inserted after “(FSOM)” in the last bullet.
Worksheet
corrigenda
The following corrigenda apply ONLY to the worksheets. The text and methods in the main volume are correct as printed, this corrigenda makes the worksheets consistent with the main text. The corrected worksheets are presented in Annex1 and 2.
Volume 2: Energy
- The
worksheets for 1B1 (pages A1.11-A1.12) should be replaced by those presented in
annex 1 to this corrigenda. In worksheets for 1.B.1.a.i (sheets 1of3 and 2 of
3) need additional columns to account for any captured methane. Similarly sheet
3 of 3 needs an additional column for a factor to account of the combustion
efficiency. In these tables (and also for 1.B.1.a.ii) the amount of coal mined
should be the same as the amount of coal undergoing post-mining activities. See
Annex1.
Volume 5: Waste (see Annex2)
- Page A1.4, column C should be “C = (A x B) x 10-3” not “E = (C-D) x 10-3”.
- Page
A1.5, footnote 5 and page A1.7, footnote 6: replace “reported only once (either
for total MSW or the components)” with “reported either for total MSW or its
components”.
- Page
A1.5, Category is “Waste Incineration” not “Incineration and Open Burning of
Waste”.
- Page
A1.6, Category is “Open Burning of Waste” not “Incineration and Open Burning of
Waste”. Category Code should be 4C2 and column F should be “F = A x B x C x D x
E x 10-6” not “F = A x B x C x D x E”.
- Page
A1.7, Category is “Open Burning of Waste” not “Incineration and Open Burning of
Waste. Column F should be “F= A x B x C x D x E x10-6” not “F= A x B
x C x D”.
- Page
A1.8, Category is “Waste Incineration” not “Incineration and Open Burning of
Waste”
- Page
A1.9, Category is “Waste Incineration” not “Incineration and Open Burning of
Waste”. Footnote 1: replace “refer to dry weight instead” with “refer to dry
waste instead”. Replace footnote 2 with “10-6 converts result into
Gg”.
- Page A1.10, Category is “Open Burning of Waste” not “Incineration and Open Burning of Waste”. Footnote 2: replace “refer to dry weight instead” with “refer to dry waste instead”. Replace footnote 3 with “10-6 converts result into Gg”.
- Page
A1.11, Category is “Waste Incineration” not “Incineration and Open Burning of
Waste”. Footnote 1: replace “CH4 emission factor” with “N2O
emission factor” and replace “refer to dry weight instead” with “refer to dry
waste instead”. Replace footnote 2 with “10-6 converts result into
Gg”.
- Page
A1.12, Category is “Open Burning of Waste” not “Incineration and Open Burning of
Waste”. Column F: the unit should be “Dry Weight” not “Wet Weight”. Footnote 1:
replace with “These data are given by multiplying columns F and G in sheet 1 of
1 “Estimation of CO2 emissions from Open Burning of Waste” in page
A1.7”. Delete footnote 2. Footnote 3 is replaced by new footnote 2 “10-6
converts result into Gg”
- Page
A1.13, column B: replace “cap.yr” with “cap/yr” and footnote 1: replace
“cap.day” and “cap.yr” with “cap/day“ and “cap/yr ”, respectively.
Footnote 2: add at end “(see page 6.14)”.
- Page
A1.17, column C: change “BOD” to “COD”.
- Page
A1.18, column C: change “BOD” to “COD”
- Page
A1.20, units for column D and E should be “kg N2O/year” instead of
“kg N2O-N/year”.
Simon Eggleston
Head, Technical Support Unit
IPCC Task Force on National Greenhouse Gas Inventories
August 2011
|